Business
 

Machining Services

At R&G Machining, our in-shop machining methods are state-of-the-art and cost-effective.
Cast iron engine blocks, crankshafts and connecting rods are cleaned. Aluminum blocks and heads are chemically cleaned. All parts are washed in a hi-pressure jet wash prior to inspection and machining.
Machine capabilities for precise and accurate tolerances to ensure top-quality performance, durability and longevity.

Engine Block Aluminum

  • Degrease by Chemical & Hi-Pressure Wash
  • Pressure Test
  • Bore and Hone
  • Hone only
  • Line Hone
  • Block Decking
  • Bolt Hole & Thread Repair
  • Replace Freeze & Galley Plugs
  • Replace Cam Bearings
  • Install Cylinder Sleeve

Cylinder Head Cast Iron

  • Degrease
  • Magnaflux
  • Pressure Test (V8/V6)
  • Pressure Test (Straight 6)
  • Install Cam Bearings
  • Install Freeze Plugs
  • Replace Valve Seats
  • Install Bronze Guide Liners
  • Replace Valve Guides
  • Crack Repair Cast Iron by Stitching
  • Machine Valve Seats 3 Angle Cut
    • V-8
    • V-6
    • 4 Valve 4 Cylinder
    • L-6 -
  • Machine for PC Seals - V-8
  • Machine Valve Spring Pockets for Oversize V-8
  • Regrind Valves -
  • Enlarge Valve Bowels -
  • Machine for Screw in Studs - V-8 Heads / includes removing studs
  • Spark Plug Hole Thread Repair -
  • Bolt Hole & Stud Repair -
  • Remove Pressed In Studs -
  • Resurface Head Gasket Surface Area - starting at $65

Connecting Rod Reconditioning

  • Degrease - $30
  • Inspect for Straightness
  • Machine to Fit Pin
  • Machine and Install Brass Bushing
  • Machine Small End for Free Float
  • Re-size Large End (if applicable)

Engine Block 6 or 8 Cylinder

  • Degrease Cast Iron $60
  • Magnaflux Cast iron Head $30
  • Bore and Hone $20/cylinder
  • Hone only $10/cylinder
  • Line Hone $125 + cost of cap (if needed)
  • Block Decking
  • Bolt Hole & Thread Repair
  • Replace Freeze and Galley Plugs
  • Replace Cam Bearings $ + cost of bearing
  • Install Cylinder Sleeves $ + cost of sleeve
  • Minor Crack Repair by Stitching
  • Minor Cast Iron Welding

Cylinder Head Aluminum

  • Degrease Starting at $
  • Pressure Test Starting at $
  • Install Freeze Plugs $/each
  • Replace Valve Seats $/each
  • Replace Valve Guides $/each
  • Machine Valve Seats for 3 Angle Cut
    • V8 $75
    • V6 $65
    • 4 Cyl. $80
  • Regrind Valves $/each
  • Spark Plug Hole Thread Repair Estimate
  • Resurface Head Gasket Surface Area $/head
  • Minor Aluminum Welding Estimate

Crankshaft

  • Degrease $
  • Check for Straightness $
  • Inspect and Measure w/ Micrometer $
  • Rod Journal Weld $
  • Main Journal Weld $
  • Thrust Weld $
  • Thread Repair
  • Regrind $
  • Polish $
     
     
All prices subject to change!

© Copyright R&G Machining and Engine parts Inc. All Rights Reserved.